Brace-it - the home of thru joist, innovative building solutions.

Welcome to BRACE-IT™ LIMITED we design and market a range of THRU-JOIST™ brackets

The full THRU-JOIST™ Bracket range are available nationwide from leading building supply merchants.

PO Box 558,
Whangaparaoa,
Auckland 0943,
New Zealand.

Ph +64 9 424 0916
Fax +64 9 424 0475
info@brace-it.com

Bracket needs to be installed firmly up against under side of joist and all holes nailed off before drilling service duct hole.
Galv Bracket 30mm x 3.15 dia hot dip galvanised nails to be used in NZ.
Galv Bracket 35mm x 3.15 dia hot dip galvanised nails to be used in Australia.
Nail ALL holes.
Maximum hole cut is 121mm dia in 190mm, 240 and 290mm THRU-JOIST™ or 68mm dia in 140mm THRU-JOIST™ brackets.
Use TJ140 on 140mm joist, TJ190 on 190mm, TJ240 on 240mm and TJ 290 on the 290mm joist.
Obtain fall for plumbing pipes by drilling holes at varying heights, within drilling circle, on adjacent joists.
No limitation on where THRU-JOIST™ brackets may be installed along the length of joist.
Use of multiple brackets on one joist must have minimum of 1500mm spacing between centres.
NOT TO BE USED IN EXTERIOR OR SUB FLOOR SITUATIONS.
Nails are not provided.
The purchaser is responsible for checking that THRU-JOIST™ brackets are suitable for there intended use.